Recovering emc dead path
# powermt display dev=all
And you notice that there are "dead" paths, then these are the commands to run in order to set these paths back to "alive" again, of course, AFTER ensuring that any SAN related issues are resolved.
To have PowerPath scan all devices and mark any dead devices as alive, if it finds that a device is in fact capable of doing I/O commands, run:
# powermt restore To delete any dead paths, and to reconfigure them again:
# powermt reset
# powermt config
Or you could run:
# powermt check
And you notice that there are "dead" paths, then these are the commands to run in order to set these paths back to "alive" again, of course, AFTER ensuring that any SAN related issues are resolved.
To have PowerPath scan all devices and mark any dead devices as alive, if it finds that a device is in fact capable of doing I/O commands, run:
# powermt restore To delete any dead paths, and to reconfigure them again:
# powermt reset
# powermt config
Or you could run:
# powermt check
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.